Dear ,
Does your facility have a winding/unwinding application requiring a simplified microprocessor based system? A system that
works without the need of a computer for configuration? Carotron has the solution with our Model MM3000-CRG Center Reference Generator. Its simple user interface allows high level microprocessor control of an application.
Model MM3000-CRG is part of Carotron's MicroManager 3000 Series. It was developed to enhance velocity mode winding
applications as well as torque mode winding/unwinding applications. Using a potentiometer input to the MicroManager in velocity mode, the winder sets/controls the line speed. The MicroManager calculates the required center driven take-up speed to maintain the desired line speed.
Other features
include:
* Can be used on torque mode winders and unwinders (brake and driven).
* Ideal in applications requiring more precise torque control than torque taper schemes, but less than full-featured CTCW (constant tension center wind)
methods.
* For winders, MM3000-CRG can operate with a drive in either the velocity or torque mode.
* For unwinders, with a brake or drive in the torque mode.
* Features four methods for
obtaining the roll diameter.
* Din-rail mountable and compact design.
Typical applications for Model MM3000-CRG include, but aren't limited to:
* Center take up
* Loop control
* PID control
* Dancer position
*
Center winder
* Extruder control
* Spiral calculator
* Signal conditioning
* Brake let off
or control
* I/O to Modbus
* ...and more!
Click the button below to visit the Carotron web page featuring this MicroManager and other products. A brochure and
instruction manual are also available for download...
